Filter
Top Products
76
1
Set the camera’s exposure mode to Aperture-
Priority Auto (A) or Manual (M).
2
Set the camera’s metering system to Matrix
Metering
Y
or Center-Weighted Metering
W
.
3
Set the SB-600’s flash mode to TTL auto flash.
4
Gently pull out the built-in wide-flash adapter and
position it over the flash head.
• The zoom-head position is automatically set at 14 mm
when using the built-in wide-flash adapter.
•To slide the wide-flash adapter back into place, lift
and push it into the flash head as far as it will go.
5
Confirm that the ready-light is on, then shoot.
• When the flash has fired at its maximum output and
underexposure may have occurred, the ready-light on
the SB-600 blinks for approx. 3 sec. To compensate,
use a wider aperture or move closer to the subject
and reshoot.
Close-up flash operation