Olympus 227575 Camcorder User Manual


 
63
EN
Battery Handling Precautions
This camera uses a lithium ion battery speci ed by
Olympus. Do not use any other type of battery.
If the battery’s terminals get wet or greasy, camera
contact failure may result. Wipe the battery well
with a dry cloth before use.
Always charge a battery when using it for the rst
time, or if it has not been used for a long period.
When operating the camera with battery power
at low temperatures, try to keep the camera and
spare battery as warm as possible. A battery that
has run down at low temperatures may be restored
after it is warmed at room temperature.
The number of pictures you can take may vary
depending on the shooting conditions or battery.
Before going on a long trip, and especially before
traveling abroad, purchase extra batteries. A
recommended battery may be dif cult to obtain
while traveling.
Please recycle batteries to help save our planet’s
resources. When you throw away dead batteries,
be sure to cover their terminals and always
observe local laws and regulations.
LCD Monitor
Do not push the monitor forcibly; otherwise the
image may become vague, resulting in a playback
mode failure or damage to the monitor.
A strip of light may appear on the top/bottom of the
monitor, but this is not a malfunction.
When a subject is viewed diagonally in the
camera, the edges may appear zigzagged on the
monitor. This is not a malfunction; it will be less
noticeable in playback mode.
In places subject to low temperatures, the LCD
monitor may take a long time to turn on or its
color may change temporarily. When using the
camera in extremely cold places, it is a good idea
to occasionally place it in a warm place. An LCD
monitor exhibiting poor performance due to low
temperatures will recover in normal temperatures.
The LCD used for the monitor is made with
high-precision technology. However, black spots
or bright spots of light may appear constantly on
the LCD Monitor. Due to its characteristics or the
angle at which you are viewing the monitor, the
spot may not be uniform in color and brightness.
This is not a malfunction.
Legal and Other Notices
Olympus makes no representations or warranties
regarding any damages, or bene t expected by
using this unit lawfully, or any request from a third
person, which are caused by the inappropriate use
of this product.
Olympus makes no representations or warranties
regarding any damages or any bene t expected
by using this unit lawfully which are caused by
erasing picture data.
Disclaimer of Warranty
Olympus makes no representations or warranties,
either expressed or implied, by or concerning any
content of these written materials or software, and
in no event shall be liable for any implied warranty
of merchantability or tness for any particular
purpose or for any consequential, incidental or
indirect damages (including but not limited to
damages for loss of business pro ts, business
interruption and loss of business information)
arising from the use or inability to use these
written materials or software or equipment. Some
countries do not allow the exclusion or limitation
of liability for consequential or incidental damages
or of the implied warranty, so the above limitations
may not apply to you.
Olympus reserves all rights to this manual.
Warning
Unauthorized photographing or use of
copyrighted material may violate applicable
copyright laws. Olympus assumes no
responsibility for unauthorized photographing,
use or other acts that infringe upon the rights of
copyright owners.
Copyright Notice
All rights reserved. No part of these written
materials or this software may be reproduced
or used in any form or by any means, electronic
or mechanical, including photocopying and
recording or the use of any type of information
storage and retrieval system, without the prior
written permission of Olympus. No liability
is assumed with respect to the use of the
information contained in these written materials
or software, or for damages resulting from
the use of the information contained therein.
Olympus reserves the right to alter the features
and contents of this publication or software
without obligation or advance notice.