Filter
Top Products
43
EN
Q The light control range is not displayed on the control panel. What
is wrong?
A The light control range is not displayed in the following cases:
When the extension tube EX-25 (optional) is used.
When the lens has been removed.
In bounce shooting.
While adjusting the flash intensity.
When the ISO sensitivity and aperture value are out of the setting range.
Q The flash wasn’t emitted when shooting in RC mode. What is
wrong?
A Verify that the camera and the electronic flash are set to the same
channel and that the group is set correctly (g P. 35).
Q How can I find out if my camera is compatible with wireless flash?
A You can use the RC mode only with cameras compatible with the
Olympus wireless RC flash system. With other cameras you may
be able to use the electronic flash as slave flash if the camera’s
built-in flash can be set to slave flash mode or manual flash mode.
For details, refer to the camera’s instruction manual.
Q When the Olympus digital camera entered the sleep mode, the
control panel on the electronic flash turned off as well. Is this
normal?
A Yes, it is normal. When the camera enters the sleep mode, the
FL-50R does as well. When the camera wakes up, so does the
FL-50R.
Q Does the FL-50R also turn off when the Olympus digital camera is
turned off?
A When the camera is turned off, the FL-50R enters the sleep mode.
When the camera is turned on again, the FL-50R also turns on.
When you want to turn off the FL-50R, turn off the FL-50R before
turning off the camera. In addition, when connected to a camera
without communication capability, the FL-50R enters the sleep
mode if it is not operated for about 60 minutes.