Filter
Top Products
102
8
Miscellaneous
Troubleshooting
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no
pictures on the card.
The camera is
connected to a TV.
With the lens barrier closed, press to turn
the monitor on.
Press quickly twice, or close the lens barrier
and then press to switch to the playback
mode.
NO PICTURE appears on the monitor. Record
pictures.
The monitor does not function when the video
cable is connected to the camera.
P. 22
P. 67, 68
–
P. 73
The date recorded with the image data is wrong.
The date/time is not
set.
The battery is
exhausted.
The camera has
been left with the
battery removed.
Set the date/time. The clock adjustment is not
factory-preset.
When the battery runs down, the date/time
setting is canceled.
Replace with a new battery and reset the date
and time.
If the camera is left for with the battery removed,
the date/time setting is canceled. Set the
date/time again.
P. 26
P. 14, 26
P. 26
ALL RESETis set to
ON.
Select the SETUP tab in the mode menu and set
ALL RESETto OFF.
P. 84
The brightness is not
adjusted properly.
Vertical lines appear
on the monitor.
The monitor is
exposed to direct
sunlight.
P. 88
P. 43
–
Select in the MODE MENU and adjust the
brightness.
Bright light (such as sunlight) may cause this.
Use the viewfinder.
Block the sunlight with your hand.
The monitor is hard to see.
The settings are returned to the factory default settings when the camera is turned off.
Possible cause Corrective action Ref. Page