Filter
Top Products
Getting to know your camera better
44
EN
• Once sound is added to a picture, it is not possible to erase the sound. In this case, make
a re-recording with silence.
g “R Adding sound to still pictures” (P. 21)
The size of the picture displayed on a computer screen changes depending on the computer
settings. When the monitor setting is 1,024 × 768 and you are using Internet Explorer to view
a picture with an image size of 2,048 × 1,536 at 100%; the entire picture cannot be viewed
without scrolling. There are several ways you can view the entire picture on the computer
screen.
View the picture using image browsing software
• Install the OLYMPUS Master 2 software from the provided CD-ROM.
Change the monitor setting
• The icons on the computer desktop may be rearranged. For details of changing the
settings on your computer, refer to the computer’s instruction manual.
Erasing sound recorded to still pictures
Viewing pictures on a computer
Viewing the entire picture on a computer screen
When you get an error message on the camera...
Monitor indication Possible cause Corrective action
q
CARD ERROR
There is a problem with the
card.
This card cannot be used. Insert a new
card.
q
WRITE PROTECT
Writing to the card is
prohibited.
The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
>
MEMORY FULL
The internal memory has no
available memory and
cannot store any new data.
Insert a card or erase unwanted data.
Before erasing, backup the data of
important pictures using the card or
download such pictures to a computer.
q
CARD FULL
The card has no available
memory and cannot store
any new data.
Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
L
NO PICTURE
There are no pictures in the
internal memory or on the
card.
The internal memory or the card contains
no pictures.
Record pictures.
r
PICTURE ERROR
There is a problem with the
selected picture and it
cannot be played back on
this camera.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
CARD-COVER
OPEN
The battery/card
compartment cover is open.
Close the battery/card compartment cover.
g
BATTERY EMPTY
The battery is empty. Insert a new battery. Or, charge it when
using the rechargeable battery.
The card is not being
recognized by the camera.
Or, the card is not formatted.
• Select [xD CARD CLEAN], and press
H. Take out the card and wipe the
contact area with a soft, dry cloth.
• Select [FORMAT] [YES] and press
H. All data on the card is erased.
OK
CARD SETUP
xD CARD CLEAN
FORMAT
SET
d4352_e_0000_7.book Page 44 Friday, July 6, 2007 10:32 AM