Filter
Top Products
En 27
En
J USING THE FLASH
1
Press the power switch.
• The camera turns on in the shooting mode.
• The lens extends and the monitor turns on.
• The orange lamp lights.
2 Press flash mode button ( ).
• Flash setting screen is displayed.
3 Press to select the flash mode, and press .
• You can also set by pressing repeatedly.
• If not used for about 3 seconds, the camera applies the current
settings, and the setting screen disappears.
4 Press the shutter button halfway.
• When the flash is set to fire, the mark lights steadily.
5 Press the shutter button fully to take the picture.
Flash working range
W (max.): Approx. 0.2 m to 3.8 m (0.7 ft. to 12.5 ft.)
T (max.) : Approx. 0.5 m to 2.2 m (1.6 ft. to 7.2 ft.)
Auto-flash (No indication)
The flash fires automatically in low light or backlight conditions.
Red-eye reduction flash ( )
The red-eye reduction flash mode significantly reduces this phenomenon by
emitting pre-flashes before firing the regular flash.
Fill-in flash ( )
The flash fires regardless of the available light.
Flash off ( )
The flash does not fire even in low light conditions.
x450_Basic.book 27 ページ ２００４年８月２日 月曜日 午前９時３６分