Filter
Top Products
18 19
1
2
3
4
5
1. Keep the MODE button pressed
until the “year” indicator starts
blinking.
Be sure to correct the date and time after the battery has
been inserted or replaced.
2. Press the SET button to adjust the
“year” indicator. If you press the
button once, the number on the
display will advance by 1. If you
keep the button pressed, the
numbers will run in rapid
succession. If you pass the
intended number, keep pressing to
return to that number.
3. Press the MODE button once more
to make the “month” indicator
blink. Press the SET button to
adjust the “month” indicator. As
you press the MODE button, the
blinking indicator changes in the
order of “year”, “month”, “day”,
“hour” and “minute”.
4. Repeat Steps 2 and 3 to set “hour”
and “minute”. Make sure the
“minute” indicator is blinking.
5. When “minute” has been set, press
the MODE button. None of the
indicators will be blinking and date/
time correction is now complete.
CORRECTING THE DATE AND TIME
(Quartzdate models only)
1
2
3
R
E
M
O
T
E
C
O
N
T
R
O
L
R
C
-30
0
C
1. Turn the screw on the bottom of the
remote control counterclockwise to
loosen.
If the selftimer/remote control indicator doesn’t blink even
when you press the button, replace the battery with a new
one (CR2025).
How to replace the battery of the remote control (RC-300C)
2. Turn the remote control over, and
remove the cover. Remove the old
battery and insert a new battery
with
⊕ facing up as shown.
3. Replace the cover, turn the remote
control over, and turn the screw on
the bottom clockwise to tighten.
RC-300C (Optional)
2756 Q50N_EN 03.6.3, 10:13 AM18-19