Filter
Top Products
16 17
SELFTIMER/REMOTE CONTROL/
CAMERA SHAKE INDICATOR
Selftimer
Secure the camera on a tripod or other support. Compose your shot in
the viewfinder. Press the shutter release button halfway (the focus and
exposure are locked at this time). Then press the shutter release button
all the way. The selftimer indicator lights for about 10 seconds and then
blinks for about 2 seconds. After this, the shutter will release.
How to select the mode
Press the selftimer/remote control
button (
). The mode switches in
the order shown below. The selected
mode is displayed on the LCD panel.
Compose your shot in the viewfinder.
Position the autofocus frame on your
subject. To take a picture, point the
remote control at the camera and
press the button on the remote
control. The selftimer/remote control
indicator starts blinking, and the
shutter will release about 3 seconds
later.
Remote Control (Optional)
Camera Shake Indicator
In this mode, the camera warns you before you shoot if
camera shake is likely to cause blurring. Also, when there is
significant camera shake, this mode helps reduce blurring.
Mode display
No display
Mode
———————
Selftimer
Remote Control
Camera Shake Indicator
If the green and orange lamps blink alternately when you hold the
camera, it means that the camera is shaking and blurring may result.
Hold the camera securely until the lamps stop blinking; then press the
shutter release button.
We recommend to fix the camera by using a tripod, when shooting
subjects in dark places using the flash-off mode, night scene flash
mode, or red-eye reduction night scene flash mode.
2756 Q50N_EN 03.6.3, 10:13 AM16-17