Filter
Top Products
E-5
ቢ
Screw the camera table provided with the PT-E
series case firmly into the bottom of the cam-
era.
5 Loading the Camera and Lens
After attaching the gear to the camera’s lens, insert the camera and lens into the PT-E series case on which
the PPO-E03 is mounted.
ባ
Remove the eyecup from the camera’s viewfind-
er. If a lens cap or filter is attached to the lens or
the strap is attached to the camera, remove them
as well.
ቤ
Pull up the power switch dial, mode dial knob
and zoom/MF dial on the PT-E series case,
and turn the case’s camera table lock lever
counterclockwise to release the lock. Attach the
flash hot shoe cable as instructed in the PT-E
series case manual.
Zoom/MF dial
Mode dial knob
Power switch dial
Camera table lock lever
ብ
Confirm that the camera’s power switch is OFF.
While pulling out the zoom/MF dial on the PT-E
series case , slide the camera table with cam-
era attached as far as it will go into the camera
table mount on the inner side of the case’s front
lid.
Pull out the zoom/MF
dial further.