Filter
Top Products
43
EN
For information on using the menus, see “Using the Menu” (p. 4).
Adjusting the CCD and the image
Adjusting the CCD and the image
processing function [Pixel Mapping]
processing function [Pixel Mapping]
r (Settings 1) X Pixel Mapping
This function has already been adjusted at factory
shipping, and no adjustment is needed right
after purchase. Approximately once a year is
recommended.
For best results, wait at least one minute after taking
or viewing pictures before performing pixel mapping.
If the camera is turned off during pixel mapping, be
sure to perform it again.
To adjust the CCD and the image
To adjust the CCD and the image
processing function
processing function
Press the Q button when [Start] (Submenu 2) is
displayed.
The camera checks and adjusts the CCD and the
image processing function at the same time.
Adjusting the brightness of the monitor
Adjusting the brightness of the monitor
[
[
s
s
]
]
s (Settings 2) X s
Submenu 2 Application
Bright/Normal
Selects the monitor brightness
depending on the surrounding
brightness.
●
Saving battery power between shots
Saving battery power between shots
[Power Save]
[Power Save]
s (Settings 2) X Power Save
Submenu 2 Application
Off Cancels [Power Save].
On
When the camera is not being used
for approx. 10 seconds, the monitor
automatically turns off to save battery
power.
To resume standby mode
To resume standby mode
Press any button.
Changing the display language [
Changing the display language [
W
W
]
]
s (Settings 2) X W
Submenu 2 Application
Languages
The language for the menus and
error messages displayed on the
monitor is selected.
1 Use FGHI to select your language and press the
Q button.