Filter
Top Products
3. Push the joystick let or right to select [Date Only] or [ Date&Time]
4.
Press the Menu button to exit the menu.
• Power Saving:
The camera will automatically power off approximately 30 SEC,1MIN, 3MIN, 5MIN
(selectable) after you do not perform any operation.
Taking Pictures
• Taking a Picture
1. Turn on the camera.
2. The TFT panel will display image and symbols.
3. Slide the Function switch to
(capture status).
4. The TFT panel will display (Snapshot Mode). If icon is different,
Press the Menu button and then push the joystick down to select [Burst Snapshot ],
and then push the joystick left or right to select [single] and then press the Menu
button to exit the menu.
5. Point the camera at the subject; use the monitor screen to compose the image. (If turn
the Macro switch to
, you can take picture as close as 50cm.)
6. Holding the camera still, gently press the Shutter button to take the picture.
Note:
How to take a good shot? After gently pressing down shutter button, keep your hand
steady for 2 seconds to get best result.
• Taking Continuous Pictures
1. Make sure the Function switch is set to
. (Capture Function)
2. Press the Menu button and then push the joystick down to select [Burst Snapshot], and
then push the joystick let or right to select [Burst] and then press the Menu button
to exit the menu. And the icon will appear on the TFT panel.
3. Point the camera at the subject; use the monitor screen to compose the image.
- 9 -