Filter
Top Products
–73–
Setting the Synchro Scan Mode
1 Set the MENU SET/OFF switch to SET.
The page on which the previous setting menu operations were completed appears on the
viewfinder screen. (When the menu is used for the first time, the first page appears.)
2 Press the PAGE button repeatedly until the SYNCHRO SCAN page shown below appears.
(This operation can also be performed using the PAGEoUP/DOWN function.)
3 Press the UP (the value increases) or DOWN (the value decreases) button repeatedly to
display the desired frequency. The frequency can be switched continuously within the range
of 30.2 Hz to 250 Hz.
4 When menu operations have been completed, set the MENU SET/OFF switch to OFF. The
setting menu disappears from the viewfinder screen and the displays indicating the unit’s
current status appear at the top and bottom of the viewfinder screen.
Pressing the SYNCHRO (“o” and “p”) buttons in the SYNCHRO SCAN mode results in the
same operation which is performed when the UP and DOWN buttons mentioned above are
pressed.
|Note{
The 57.2 Hz to 60.8 Hz range cannot be set.
-
SYNCHR
O
SCAN
-
1/60.8