Filter
Top Products
Pan/Tilt Head Controller AW-RP400
20 (E)
ENGLISH
Parts and their function
1EXT CONT [M/S] switch
This switch is normally kept at the [M] (master) position.
When an additional AW-RP400 controller has been
installed, set the EXT CONT switch on the additional unit
to [S] (slave).
If no additional AW-RP400 controller is going to be
installed, the EXT CONT switch on this controller must be
kept at the [M] (master) position without fail.
2OPERATE lamp
This lights up green when the (3) OPERATE switch is at
ON. It goes off when the switch is set to OFF.
3OPERATE [OFF/ON] switch
When this switch is set to [ON], the power supply from
the connected pan/tilt heads to the cameras is turned on,
and system control is enabled.
When it is set to [OFF], the power supply from the
connected pan/tilt heads to the cameras is turned off.
4INCOM jack
The INCOM (inter-communication) headset is connected
here.
5LEVEL control
Use this to adjust the volume of the headset’s receiver.
6CALL button
When this button is pressed, the buzzer of the connected
controller sounds, and the CALL button lamp lights.
1IHGEDCBA@?>=<;F
J
K
L
2
3
4
5
6
7
8
9
:
$ Front panel
NOTE
When an additional AW-RP400 controller is installed and
used, it will not be possible to exercise control from the
slave controller unless the OPERATE switches not only
on the slave controller but on the master controller as
well are set to [ON]. Remember to set the OPERATE
switch on the slave controller to [ON] first before setting
the OPERATE switch on the master controller to [ON].