Filter
Top Products
DC14.0V
YP
BPR 1080/60I
50%
P-P
4 35
1 2
6
7
[PHASE] 32
12
How to Use the On Screen Menu
Six types of information are displayed on the screen: the operating status display, picture adjusting knob status,
sharpness display, function display, DC power supply voltage display, battery level display and menu display.
Operating status display
1. The selected input line (→ page 7,
2
)
• YP
BPR, VF-YPBPR/VF-VIDEO, VIDEO, SDI
2. Signal format
• The display status can be set in “STATUS DISPLAY”
in the “SYSTEM CONFIG” menu (→ page 21).
•
If “UNSUPPORT SIGNAL” is displayed, then either
the current input signal is not supported or the “INPUT
SELECT” menu setting needs to be changed.
• When “NO SIGNAL” is displayed, there is no input
signal.
3. Battery level display
• When an Anton/Bauer type digital battery is used,
battery level is displayed using a block count ( )
and percentage.
4. Various displays (PIXEL TO PIXEL mode)
• Displayed when the picture display is PIXEL TO
PIXEL.
5. Various displays (warning of improper operation
status for the camera settings)
• Displayed when there is an improper operation
status relative to the camera settings.
6. DC power supply voltage display
• DC power supply voltage is displayed.
7. Various displays (lock setting)
• Displayed when front operations are locked
(→ page 30).
<Note>
“UNSUPPORT SIGNAL” and “NO SIGNAL” may not be
displayed correctly.
Picture adjusting knob status
Picture adjusting knob (→ page 7,
4
)
• This knob can be rotated and pushed.
• The status display appears when the knob is pushed.
The display disappears when the knob is pushed
again, or if the knob is not operated for 10 seconds.
• The settings can be adjusted while this display is
shown, but the settings cannot be adjusted after the
display disappears.
Status display:
PEAKING or PHASE
CHROMA or FOCUS-IN-RED
BRIGHT
CONTRAST or BACKLIGHT