Panasonic DMC-LS70 Digital Camera User Manual


 
41
VQT1C63
Advanced-Shooting
*
1
The ash is activated twice. The
subject should not move until the
second ash is activated.
Available ash settings by recording
mode
The available ash settings depend on the
recording mode.
( : Available, — : Not available, : Initial
setting)
*
2
It becomes Forced ON [ ], when the
backlight compensation function is
activated.
• The ash setting may change when you
change the recording mode. Change the
ash setting again if necessary.
Flash settings are retained even if you
switch the camera off. However, scene
mode ash settings return to the factory
settings when you change the scene mode.
The available ash range to take
pictures
ISO
sensitivity
(P61)
Available ash range
AUTO 30 cm (0.98 feet) to 4.7 m
(15.42 feet) (Wide)
30 cm (0.98 feet) to 2.6 m
(8.53 feet) (Tele)
ISO100 30 cm (0.98 feet) to 1.8 m
(5.91 feet) (Wide)
30 cm (0.98 feet) to 1.0 m
(3.28 feet) (Tele)
ISO200 40 cm (1.31 feet) to 2.6 m
(8.53 feet) (Wide)
30 cm (0.98 feet) to 1.4 m
(4.59 feet) (Tele)
ISO400 60 cm (1.97 feet) to 3.7 m
(12.14 feet) (Wide)
40 cm (1.31 feet) to 2.1 m
(6.89 feet) (Tele)
ISO800 80 cm (2.62 feet) to 5.3 m
(17.39 feet) (Wide)
60 cm (1.97 feet) to 2.9 m
(9.51 feet) (Tele)
ISO1250 100 cm (3.28 feet) to 5.3 m
(17.39 feet) (Wide)
80 cm (2.62 feet) to 2.9 m
(9.51 feet) (Tele)
• Refer to P107 for the focus range.
• When you use the ash when you have
set ISO sensitivity to [AUTO] or set
ISO LIMIT in Intelligent ISO mode [ ]
to anything other than [ISO400], ISO
sensitivity automatically becomes a
maximum of [ISO640] ([ISO400] in the
[BABY1]/[BABY2] or [PET] scene modes
(P47)).
• The edges of the picture may appear
dark if you shoot a very close subject with
the ash while the zoom lever is close to
the W side. Zoom in slightly if this occurs.
**
22