Filter
Top Products
- 114 -
Others
Message Display
Confirmation messages or error messages will be displayed on the screen in some cases.
The major messages are described below as examples.
[This picture is protected]
> Delete the picture after canceling the protect setting. (P94)
[Some pictures cannot be deleted]/[This picture cannot be deleted]
•
Pictures not based on the DCF standard cannot be deleted.
> Format the card after saving necessary data on a PC etc. (P44)
[Built-in memory full]/[Memory card full]/[Not enough space on built-in memory]/
[Not enough memory on the card]
•
There is no space left on the built-in memory or the card.
•When you copy pictures from the built-in memory to the card (batch copy), the pictures are copied
until the capacity of the card becomes full.
[Some pictures cannot be copied]/[Copy could not be completed]
•
The following pictures cannot be copied.
–When a picture with the same name as the picture to be copied exists in the copy destination.
(Only when copying from a card to the built-in memory.)
–Files not based on the DCF standard.
•Moreover, pictures recorded or edited by other equipment may not be copied.
[Built-In Memory Error]/[Format built-in memory?]
•
This message will be displayed when you format the built-in memory on a PC.
> Format the built-in memory on the camera again. (P44) The data on the built-in memory will be
deleted.
[Memory card error.
This card cannot be used in this camera.
Format this card?]
•
It is a format that cannot be used with this unit.
> Insert a different card and try again.
> Reformat on this unit (P44) after saving necessary data using a PC, etc. Data will be deleted.
[Please turn camera off and then on again]/[System Error]
•
This is displayed when the lens has stopped operating normally due to being pressed on by a hand
etc.
> Turn the camera off and on. If the message persists, contact the dealer or Panasonic.