Filter
Top Products
15
VQT1V73
Preparation
Battery: Insert it fully being careful
about the direction you insert it. Pull
the lever A in the direction of the arrow
to remove the battery.
Card: Push it fully until it clicks being
careful about the direction you insert it.
To remove the card, push the card until
it clicks, then pull the card out upright.
B:Do not touch the connection terminals of the
card.
• The card may be damaged if it is not fully
inserted.
1: Close the card/battery door.
2: Slide the release lever in the
direction of the arrow.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
Note
•Remove the battery after use. Store the removed battery in the battery case (supplied).
•Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the
settings on the camera may not be stored properly.
•The supplied battery is designed only for the camera. Do not use it with any other equipment.
•Before removing the card or battery, turn the camera off, and wait until the status indicator has
gone off completely. (Otherwise, this unit may no longer operate normally and the card itself
may be damaged or the recorded pictures may be lost.)
DMC-FS7&FS6PPC-VQT1V73_eng.book 15 ページ ２００８年１２月１日 月曜日 午後５時１０分