Filter
Top Products
VQT1V73
16
Preparation
∫ Using an AC adaptor (optional) and a DC coupler (optional) instead of the battery
Ensure that the AC adaptor (DMW-AC5PP;
optional) and DC coupler (DMW-DCC4; optional)
are purchased as a set. Do not use if sold
separately.
1 Open the card/battery door.
2 Insert the DC coupler, being careful of the
direction.
3 Close the card/battery door.
• Ensure that the card/battery door is closed.
4 Open the DC coupler cover A.
5 Plug the AC adaptor into an electrical outlet.
6 Connect the AC adaptor B to the [DC IN] socket
C of the DC coupler.
D Align the marks, and insert.
•Ensure that only the AC adaptor and DC coupler for this
camera are used. Using any other equipment may
cause damage.
Note
•Always use a genuine Panasonic AC adaptor (DMW-AC5PP; optional).
•Some tripods cannot be attached when the DC coupler is connected.
•Make sure to unplug the AC adaptor when you open the card/battery door.
•If the AC adaptor and DC coupler are not necessary, then remove them from the digital
camera. Also, please keep the DC coupler cover closed.
•Also read the operating instructions for the AC adaptor and DC coupler.
•For information about optional accessories, refer to the “Digital Camera Accessory System”.
(P110)
About the Built-in Memory/the Card
The following operations can be performed using this unit.
•When a card has not been inserted: Pictures can be recorded in
the built-in memory and played back.
•When a card has been inserted: Pictures can be recorded on the
card and played back.
•When using the built-in memory
k
>ð (access indication
¢
)
•When using the card
† (access indication
¢
)
¢ The access indication lights red when pictures are being recorded
on the built-in memory (or the card).
DMC-FS7&FS6PPC-VQT1V73_eng.book 16 ページ ２００８年１２月１日 月曜日 午後５時１０分