Filter
Top Products
119
VQT1Z45
Connecting to other equipment
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the built-in memory.
A USB connection cable (supplied)
•Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may be bent out of shape which will cause trouble.)
B Align the marks, and insert.
•Use a battery with sufficient battery power or the AC adaptor (DMW-AC5PP; optional). When
using the AC adaptor (DMW-AC5PP; optional), use the multi conversion adaptor (DMW-MCA1;
optional). If the remaining battery power becomes low while the camera and the PC are
communicating, the status indicator blinks and the alarm beeps.
Refer to
“Disconnecting the USB connection cable safely” (P120) before disconnecting the
USB connection cable. Otherwise, data may be destroyed.
Connect the camera to a PC via the USB connection cable A
(supplied).
• Do not use any other USB connection cables except the supplied one.
Use of cables other than the supplied USB connection cable may cause malfunction.
Acquiring of still pictures and [MOTION JPEG] motion pictures
(other than [AVCHD Lite] motion pictures)
Press 3/4 to select [PC], and then press
[MENU/SET].
• If [USB MODE] (P30) is set to [PC] in the [SETUP] menu in
advance, the camera will be automatically connected to the PC
without displaying the [USB MODE] selection screen. Since there
is no need to set this each time you connect to the PC, it is
convenient.
• When the camera has been connected to the PC with
[USB MODE] set to [PictBridge(PTP)], a message may appear
on the PC’s screen. Select [Cancel] to close the screen, and
disconnect the camera from the PC. Then set [USB MODE] to
[PC] again.
USB MODE
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
SELECT
SET
VQT1Z45~_eng.book 119 ページ ２００９年１月２８日 水曜日 午後９時３０分