Filter
Top Products
12 VQT1Z96 (ENG) (ENG) VQT1Z96 13
Inserting battery and card
Battery
(check orientation)
Card
(check orientation)
Do not touch terminal
Status indicator
Set the camera ON/OFF switch to OFF
Slide to the ‘OPEN’ position
and open the lid
OPEN
LOCK
Release lever
Completely insert battery
and card
(both click into place)
Close lid
Slide to the ‘LOCK’ position.
To remove
• To remove battery: • To remove card:
move lever in
direction of arrow.
Lever
press down in
centre.
Always use genuine Panasonic batteries (DMW-BCG10E).
If you use other batteries, we cannot guarantee the quality of this product.
Do not remove card or battery while power is ‘ON’ or while status indicator is on
(Camera may cease operating correctly, or card/recorded contents may be damaged).
The reading/writing speed of a MultiMediaCard is slower than an SD memory card.
When a MultiMediaCard is used, the performance of certain features may be slightly
slower than advertised.
Keep the Memory Card out of reach of children to prevent swallowing.
Remaining battery and memory capacity
Pictures remaining
Displayed when no card inserted (pictures will be saved to built-in memory)
Remaining battery (only when using battery)
(flashes red)
If the battery mark flashes red (or status indicator flashed when LCD
monitor is off), recharge or replace battery. (P.10)
When in operation
(Card) or (Built-in memory) are illuminated red.
This means that an operation is in progress, such as the recording, reading, deleting,
or formatting of pictures. Do not turn off the power or remove the battery, card, or AC
adaptor (optional) (this may cause damage to or loss of data).
Do not subject the camera to vibrations, impact, or static electricity. Should any of these
cause camera operation to be terminated, attempt to perform the operation again.
It is recommended that you copy important pictures to your computer (as
electromagnetic waves, static electricity, or faults may cause data to be damaged).
For model numbers and types,
see http://panasonic.co.jp/pavc/global/cs (This Site is English only.)
Picture save destination (cards and built-in memory)
Pictures will be saved to a card if one is inserted, or to the built-in memory if not.
Compatible memory cards (optional)
The following SD standard-based cards (Panasonic brand recommended)
• SD memory cards (8 MB - 2 GB)
• SDHC memory cards (4 GB - 32 GB)
Can only be used with devices compatible with SDHC memory cards.
(Always read your device’s operating instructions before proceeding)
•
Cards of over 4 GB may only be used if they have the SDHC logo.
Please reformat the card with this camera if it has already
been formatted with a computer or another device.
If the switch on the card is set to ‘LOCK’, operations such as
formatting, recording, and deleting cannot be performed.
MultiMediaCards may also be used (for pictures only)
Built-in memory (approx. 40 MB)
Built-in memory is slower than SD memory card.
‘QVGA’ in ‘REC QUALITY’ only can be available to record motion pictures in the built-in memory.
Clipboard pictures are saved to built-in memory.
Pictures may be copied between cards and the built-in memory.
Switch
(LOCK)
32
3232
SD memory card/
SDHC memory card
(optional)
SDHC logo