- 30 -
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick Start Standby Mode about 60% of the power used in recording pause mode
is being consumed, so the recording time will be reduced.
≥ Quick Start will not work if there is no SD card inserted.
≥ Change the mode to .
1 Select the menu.
2 Close the LCD monitor.
The status indicator A flashes green and the unit goes into
Quick Start Standby Mode.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put into
recording pause.
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.
≥ When it has gone into Quick Start Standby Mode automatically with the [ECONOMY (BATT)]
(l 29)/[ECONOMY (AC)] (l 29), close the LCD monitor once and open it again.
≥ Turn the unit off using the power button.
[QUICK START]
: [SETUP] # [QUICK START] # [ON]