76
VQT1Z09
Bass setting
Change the lower setting of the built-in microphone according
to your choice.
≥ Change the mode to .
≥ The Intelligent Auto Mode is set to off. (l 47)
Select the menu. (l 33)
[RECORD SETUP] # [BASS SETTING] # desired setting
[0dB]/[+3dB]/[+6dB]/[LOWCUT]
≥ Normally set to [0dB].
≥ Select [+3dB] or [+6dB] to get strong power feeling at bass level.
Select [LOWCUT], when recording is done outside in strong wind
or when wind noise cannot be reduced only with the wind noise
reduction function.
Zebra
A Zebra pattern
Parts where white saturation (color saturation) is likely to
occur (extremely brightly lit or shiny parts) are displayed with
diagonal lines (zebra pattern).
≥ Change the mode to or .
≥ The Intelligent Auto Mode is set to off. (l 47)
Select the menu. (l 33)
[RECORD SETUP] # [ZEBRA] # [ON]
≥ It is possible to set from the quick menu in Manual Mode. (l 34)
≥ You can record an image with little white saturation if you
manually adjust the shutter speed or brightness (iris/gain) (l 84).
≥ The zebra pattern does not appear on the images actually
recorded.
Luminance
[OFF]:
Not display
[ALWAYS]:
Constantly display
[ON ADJUST]:
Display only when [IRIS] is
adjusted. (l 84)
A Luminance display frame
B Luminance level
Displays the luminance level of the center of the screen
(luminance display frame) in %.
It makes the adjustment of the brightness of the object easier,
by checking the luminance level of the object, when recording
same object in different surroundings.
Adjust the brightness using [IRIS]. (l 84)
≥ Change the mode to or .
≥ The Intelligent Auto Mode is set to off. (l 47)
Select the menu. (l 33)
[RECORD SETUP] # [LUMINANCE] # desired setting
≥ It is possible to set from the quick menu in Manual Mode. (l 34)
≥ This function’s default setting is [ON ADJUST].
≥ Luminance level is displayed between [0%] and [99%]. It will be
displayed as [99% ] when it is over 99%.
Function Effect/Setting method
50%
HDCSD300&HS300P-VQT1Z09_eng.book 76 ページ 2009年1月21日 水曜日 午前9時53分