43
VQT3K35
The unit is put into recording pause approx. 1 second when the unit is turned on with the
mode set to or .
≥ Depending on the recording conditions, start time may be longer than 1 second.
≥ In the Quick power on mode, the zoom magnification becomes 1k.
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥ Quick start will not work if there is no SD card inserted.
≥ Change the mode to or .
1Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode is set to
or .
The status indicator A flashes green and the unit goes into
Quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put into
recording pause.
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
≥ Depending on the recording conditions and menu settings, time for Quick start may be
longer than 0.6 seconds.
≥ It may take some time for Automatic white balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 42) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
≥ Quick start standby mode cannot be released by the remote control.
Please refer to page 47.
[QUICK POWER ON]
[OFF]/[ON]
[QUICK START]
[OFF]/[ON]
[REMOTE CONTROL]
[OFF]/[ON]
HDCSD800P-VQT3K35_mst.book 43 ページ 2010年12月20日 月曜日 午前9時4分