80
VQT1Z09
Night portrait
≥ The shutter speed is 1/2 or more.
≥ The flash is set to [ON].
≥ Using a tripod is recommended.
Interval recording:
≥ Still picture recording cannot be used.
≥ Recording mode cannot be changed when the
interval recording is set.
≥ If you turn off the power or change the mode to
, this function is canceled.
≥ 1 second of motion picture is recorded even if
24 frames are not recorded at the end of
recording.
≥ Color balance and focus may not be adjusted
automatically depending on light sources or
scenes. If so, manually adjust these settings.
(l 83, 85)
Digital cinema:
≥ Motion pictures recorded while this setting is
turned [ON] may not be played back properly
with a player that cannot support 24p video
signal playback.
Relay recording:
≥ It does not allow the relay recording of still
pictures. However, even still pictures are
recorded to the SD card after relay recording.
≥ is displayed on the thumbnail display
during the playback of a scene that was relay
recorded on the built-in memory.
Auto Ground-Directional Standby
≥ The AGS function may activate and cause the
unit to pause the recording if you are recording
a subject right above or right below you.
Auto slow shutter:
≥ When the shutter speed becomes 1/30, the
screen may be seen as if frames are missed
and afterimages may appear.
Digital cinema color:
≥ When motion pictures recorded while this
function is turned [ON] are played back
with a TV not compatible with x.v.Color
™
,
colors may not be reproduced properly.
≥ To play back images recorded in Digital cinema
color with vivid colors of wider color ranges, a
device compatible with x.v.Color
™
is required.
When these images are played back with
devices other than ones compatible with
x.v.Color
™
, it is recommended to record the
images after this function is turned [OFF].
≥ x.v.Color
™
is a name for devices that are
compatible with the xvYCC format, an
international standard for expanded color in
motion pictures, and that follow the rules for
signal transmission.
Wind noise reduction:
≥ When the Intelligent Auto Mode is set to on,
[WIND CUT] is set to [ON], and the setting
cannot be changed.
≥ The sound quality may be changed if this
function is activated in strong winds.
≥ If wind sound cannot be reduced with the wind
noise reduction function alone, set [BASS
SETTING] to [LOWCUT]. (l 76)
Microphone setup:
≥ If you wish to record higher quality sound and
maintain realism even when zooming in, for
instance, when recording a music recital, we
recommend setting [MIC SETUP] to
[SURROUND].
Microphone level:
≥ When the Intelligent Auto Mode is on, the
setting is fixed to [AUTO] and cannot be
changed.
≥ When [MIC SETUP] is [ZOOM MIC], the
volume will be different depending on the zoom
rate.
≥ Audio becomes stereo (2 ch) when input is
from an external microphone, and the front left
and front right gain values only work.
≥ The microphone input level meter shows the
largest volume for the microphones.
≥ You cannot record with the audio completely
muted.
Luminance:
≥ Luminance is displayed while adjusting [IRIS]
even if [DISPLAY] is set to [OFF].
Histogram:
≥ Histogram is displayed while adjusting [IRIS]
even if [DISPLAY] is set to [OFF].
HDCSD300&HS300P-VQT1Z09_eng.book 80 ページ 2009年1月21日 水曜日 午前9時53分