42
VQT3J56
The unit is put into recording pause approx. 1 second when the unit is turned on with the
mode set to or .
≥ Depending on the recording conditions, start time may be longer than 1 second.
≥ In the Quick power on mode, the zoom magnification becomes 1k.
This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened.
≥ When in Quick start standby mode about 80% of the power used in Recording pause
mode is being consumed, so the recording time will be reduced.
≥
Quick start will not work if there is no SD card inserted.
≥
Quick start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there
is no SD card inserted.
≥ Change the mode to or .
1Set [QUICK START] to [ON].
2 Close the LCD monitor while the mode
is set to or .
The status indicator A flashes green and the unit
goes into Quick start standby mode.
≥ The lens cover does not close.
3 Open the LCD monitor.
The status indicator A lights red and the unit is put
into recording pause.
≥ Quick Start Standby Mode is canceled if:
jabout 5 minutes have elapsed
jmode is set to
≥ Depending on the recording conditions and menu settings, time for Quick start may be
longer than 0.6 seconds.
≥ It may take some time for Automatic white balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes 1k.
≥ If [ECONOMY] (l 41) is set to [5 MINUTES] and the unit automatically goes into Quick
Start Standby Mode, close the LCD monitor and then open it again.
≥ Turn the unit off using the power button.
[QUICK POWER ON]
[OFF]/[ON]
[QUICK START]
[OFF]/[ON]
HDC-SD90
HDC-TM90
HDC-SD90&TM90-P-VQT3J56_mst.book 42 ページ 2011年1月13日 木曜日 午前9時18分