Filter
Top Products
Operating Instructions
102
Wall Mounting
1) Mount the Flexible Stand firmly to a wall or beam using the three
screws (accessories). Set the Flexible Stand 240 mm (9.5 inches) away
from the ceiling.
• Use appropriate screws suited for the material of the wall.
2) Attach Network Camera by screwing the threaded mount into the tripod
mounting hole. A mounting hole on the rear side is also available.
3) Adjust the position of Network Camera and secure the Flexible Stand
firmly.
4) Roll up the cables and Flexible Stand with the Self Bonding tape
(accessories). Refer to page 96 for waterproofing the cables.
1) 2)
3)
4)
Caulk around Flexible
Stand if necessary.
Self Bonding tape
240 mm
(9.5 inches)
Waterproof the rest
of the cable.