Filter
Top Products
Operating Instructions
98
4.1.1 Network Camera Cabling
Check the location where Network Camera should be installed. Select the proper
cablesuitedtoNetworkCameralocation.Consultanauthorizedwiringelectrician
for cabling.
1. Raise the antenna vertically (1.), and put the cables through the Connector
Cover (2.). Connect the DC plug of the AC adaptor to the DC IN jack (3.).
Connect the AC plug of the AC adaptor to the power outlet (4.).
Notes
• Mounting and cabling instructions described in this Operating Instructions
follow generally accepted guidelines suitable for residential installations. In
some areas, commercial and industrial installations are regulated by local
or state ordinances. For such installations, contact your local building
department or building inspector for more details.
• Ethernet cable, External I/O and Ground should be connected and
threaded through Connector Cover. Once you putty the cables, External I/
O and Ground cannot be connected until you take the putty off.
• Check the location of Network Camera, the type and the length of the
Ethernet cable (Max. 100 m [330 feet]). Use an Ethernet cable as short as
possible for outdoor use. Lightning may cause serious damage to Network
Camera or the connected devices.
• Use a category 5 cross cable (if necessary) when connecting directly to a
PC.
DC IN
jack
DC Plug
Connector
Cover
(1.)
(3.)
(4.)
(2.)
AC adaptor
Power
Outlet