Filter
Top Products
Operating Instructions
38
Note
• Some wireless devices do not support the WEP 152 bit encryption.
• The camera supports only open system authentication. If the wireless
router or access point is set to shared key authentication, set it to auto or
open system.
4. Click [Save] when finished.
• The new settings are saved.
• When finished, "Success!" is displayed.
5. Click [Go to Wireless configuration page].
• The Wireless page is displayed.
6. Set the switch to WIRELESS.
Note
• Encryption helps protect data within wireless LAN from third parties.
• Enter both the MAC addresses for the camera itself and the camera's
wireless module to enable the MAC address filtering feature on the
wireless router. The wireless module MAC address is one value higher
than the camera MAC address.
• It takes about 1 minute for the new settings to become effective.
• It is not possible to access the camera simultaneously by both wired and
wireless connection.
• To communicate using wireless connection, set up the camera using wired
connection and flip the switch from WIRED to WIRELESS as shown
below.
• Even if the camera is set to wired connection, it emits electrical waves for
about 5 minutes after the power has been on. During this time, the router's
wireless indicator is on or blinking. Electrical waves will stop being
transmitted after about 5 minutes.
• When you switch from WIRED to WIRELESS or vice versa, restart the
camera. Some routers may also need to be restarted after switching.
Switch
< Side >