Filter
Top Products
Others
41
LSQT1174
4:Auto focus function does not work.
• Is manual focus mode selected? If auto focus
mode is selected, focus is automatically
adjusted.
• There are some recording subjects and
surroundings for which the auto focus does not
operate correctly. (
-46-) If so, use the manual
focus mode to adjust the focus. (
-27-)
• Is the colour night view function set? When the
colour night view function is working, focusing
shifts into the manual mode.
Indications
1:A sentence is displayed in red in the screen
centre.
• Read the contents and respond to them. (
-38-)
2:The remaining tape time indication
disappears.
• The remaining tape time indication may
disappear temporarily during frame-by-frame
playback or other operation. If you continue
ordinary recording or playback, the indication is
restored.
3:The remaining tape time Indication does not
match the actual remaining tape time.
• If scenes of less than 15 seconds are
continuously recorded, the remaining tape time
cannot be correctly displayed.
• In some cases, the remaining tape time
indication may show remaining tape time that is
2 to 3 minutes shorter than the actual
remaining tape time.
4:A function indication such as mode
indication, remaining tape time indication,
or time code indication is not shown.
• If you set [SETUP] >> [DISPLAY] >> [OFF],
indications other than the tape running
condition, warning, and date indications
disappear.
Playback (Sound)
1:Sound is not played back from the built-in
speaker of the movie camera.
0 Is the volume too low? During playback, push
the [jVOLUMEi] lever to display the volume
indication and adjust it. (
-29-)
2:Different sounds are reproduced at the
same time.
• Have you set [SETUP] >> [AUDIO OUT] >>
[STEREO] and reproduced a picture containing
the main sound and sub sound? Set to [L] to
hear main sound, and set to [R] to hear the sub
sound. (
-37-)
3:Sounds cannot be played back.
• Have you set [SETUP] >> [12bit AUDIO] >>
[ST2]? Set [12bit AUDIO] >> [ST1]. (
-37-)
Playback (Pictures)
1:Mosaic-pattern noise appears on images
during cue or review playback.
• This phenomenon is characteristic of digital
video systems. It is not a malfunction.
2:Horizontal stripes appear on images during
cue and review playback.
• Horizontal stripes may appear depending on
the scene, but this is not a malfunction.
3:Although the movie camera is correctly
connected to a TV, playback images cannot
be seen.
• Have you selected video input on the TV?
Please read the operating instructions of your
TV and select the channel that matches the
input terminals used for the connection.
4:Playback picture is not clear.
• Are the heads of the movie camera dirty? If the
heads are dirty, playback image cannot be
clear. Clean the heads by using the head
cleaner for digital video. (
-43-)
• If the terminal for the AV cable is soiled, noises
may appear on the screen. Wipe the soil off the
terminal with a soft cloth, and then connect the
cable to the AV terminal.
• Is a picture containing a copyright protection
signal (copy guard) being recorded? When a
protected picture is played back by the movie
camera, mosaic-like patterns appear on the
picture.
LSQT1174ENG.book 41 ページ ２００７年１月２９日 月曜日 午後１時２８分