Filter
Top Products
22
5. Aim the camera at the targeting objects and if applicable adjust the zoom angle.
6. Press the [DOWN] button.
→ The LED indicator will light up, and a bar graph with "I" cursor and INDICATOR (4-digit
number) will be overlaid on the camera picture.
→ Back focus will be automatically adjusted.
7. If needed, perform manual adjustment using the L and R buttons to obtain the best focus
on the targeted object while observing the picture. See INDICATOR on the monitor for ref-
erence.
Notes:
• The bar graph will disappear if no operation is performed for around 10 seconds.
• When changing the angular field of view, move the zoom lever and focus lever again for
adjustment.
Zoom/focus adjustment
When shooting an object using an AF lens, the first adjusted focus may be out-of-focus
depending on the focal depth of the lens in use. In this case, focus on a darker object with the
aperture open to prevent out-of-focus.
When "ABF" is selected for "BACK-FOCUS" on the SETUP menu (refer to p. 41), the camera
can automatically focus on a subject with the best available conditions even when the illumina-
tion changes.
• Under near-infrared light, the focus may be slightly out-of-focus than under visible light.
When the "BACK-FOCUS SETUP" page is displayed and "AUTO" or "PRESET" is selected
for "C/L" ↔ B/W" using the operation buttons on the camera, the camera can focus on sub-
jects both under near-infrared light and under visible light. (However, the camera will not
change the focus according to the illumination change when the focus had been adjusted
once.)
<How to use a varifocal lens>
Before adjusting the varifocal lens, reset the flange-back length position to the default
position for the CS-mount (by simultaneously pressing the [LEFT] and [RIGHT] buttons for
2 seconds or more, or by simultaneously pressing the [LEFT] and [RIGHT] buttons after
pressing the [SET] button when the cursor is on "MANUAL-ADJ" on the "BACK-FOCUS
SETUP" page.
NEAR FAR
.........
|
..........
INDICATOR 255 FOCUSING