Filter
Top Products
32
• To erase all characters of the camera ID, select RESET and press the [SET] button.
Note: For Chinese language, up to 8 characters can be entered.
4. To specify the ID display position:
1. Select POSI and press SET.
→ The entered camera ID will be highlighted on the screen.
2. Move it into the appropriate position and press SET.
→ The position is determined and the screen will return to the CAMERA ID menu.
Note: Keep pressing any of [LEFT], [RIGHT], [UP], or [DOWN] button for a second or
more to move the camera ID faster as necessary.
2. Light Control Mode Setting (ALC)
Select a light control mode depending on the lens type mounted. The default setting is ALC.
ALC↓: Is applicable to the auto iris lens. SUPER-D3 is available with this selection.
2-1. ALC Mode with SUPER-D3 ON
Super Dynamic 3 Function (SUPER-D3)
In the SUPER-D3 mode, more photometric weight is given to the center of the screen than to
the edge where a bright backlight would most likely be located.
Nighttime
Nighttime
Daytime
Daytime
SUPER-D3 ON SUPER-D3 OFF
SUPER-D3 ON: Enables SUPER-D3 to compensate backlight automatically.
SUPER-D3 OFF: Enables manual setting to compensate backlight.
Notes:
• When set to ON, the available parameters for SHUTTER and SENS-UP will be limited as
shown on the next page.
• Set SUPER-D3 to OFF when noise in a bright portion, flickerings, or color deterioration are
observed.
1. Move the cursor to ALC.
→ The ALC CONT menu opens.
2. Select ON for SUPER-D3.
3. Adjust the video output level (LEVEL) by
moving the "I" cursor. It may be better to
adjust LEVEL slightly higher.
**ALC CONT**
BACK LIGHT COMP
SUPER-D3 ON
LEVEL ..I...128
- +
RET TOP END