Filter
Top Products
Others
108
Message Display
[NO MEMORY CARD]
Insert the card.
[THIS MEMORY CARD IS PROTECTED]
Cancel the card lock.
[NO VALID IMAGE TO PLAY]
Play back after recording or after inserting
a card with a recorded picture.
[MEMORY CARD FULL/
NOT ENOUGH MEMORY IN THE CARD]
Insert a new card or delete the
unnecessary data.
[PLEASE CLOSE THE FLASH]
Be sure to close the flash after use.
[MODE DIAL IS NOT IN THE PROPER
POSITION]
This message appears when you turn the
camera on with the mode dial in the wrong
position.
Rotate the mode dial to the proper position.
[PLEASE SET THE CLOCK]
This message appears when you use the
camera for the first time or you do not use
the camera for a long time. Set the clock.
[THIS PICTURE IS PROTECTED]
After canceling the protect setting, you can
delete or overwrite the picture.
[THIS PICTURE CAN’T BE DELETED /
SOME PICTURES CAN’T BE DELETED]
The pictures not based on the DCF
standard cannot be deleted.
[CAN’T BE SET ON THIS PICTURE /
CAN’T BE SET ON SOME PICTURES]
If the pictures are not based on the DCF
standard, the DPOF print cannot be set.
[NO ADDITIONAL DELETE SELECTIONS
CAN BE MADE]
You have exceeded the number of pictures
that can be set at once with multi-delete
setting.
[MEMORY CARD ERROR FORMAT THIS
CARD?]
The format of the card cannot be
recognized by this camera. Format the card
again with this camera.
[PLEASE TURN CAMERA OFF AND
THEN ON AGAIN]
This message appears when the camera
does not operate properly. Turn the camera
off and on. If the message persists, contact
the dealer or your nearest servicenter.
[MEMORY CARD ERROR]
Failed access to the card.
Insert the card again.
[READ ERROR]
Data reading error.
Play it back again.
[WRITE ERROR]
Data writing error.
Turn the camera off and remove the card.
Then insert the card and turn the camera
on again. Be sure that the camera is turned
off before removing or inserting the card to
avoid damage.
FZ3-PP.book 108 ページ ２００４年６月２１日 月曜日 午後７時６分