Before using
14
LSQT1121
Power supply
ª Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
≥Battery charging time. (
-15-)
≥We recommend using Panasonic batteries.
(
-11-, -72-)
≥If you use other batteries, we cannot guarantee
the quality of this product.
≥If the DC Cable is connected to the AC adaptor,
then the battery will not get charged. Remove
the DC Cable from the AC adaptor.
1 Connect the AC Cable to the AC adaptor
and the AC Jack.
2 Put the battery on the battery mount by
aligning the mark, and then securely plug it
in.
ª
Charging lamp
Lights up:Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the [CHARGE]
lamp flashes and the charging time will
be longer than normal.
ª
Connecting to the AC outlet
1
Connect the AC Cable to the AC adaptor
and the AC Jack.
2 Connect the DC Cable to the AC adaptor.
3 Connect the DC Cable to this product.
≥The output plug of the AC Cable is not
completely connected to the AC adaptor jack.
As shown in 1, there is a gap.
≥Do not use the power cord for other
equipment since the power cord is exclusively
designed for this Camcorder. Do not use the
power cord from other equipment for this
Camcorder.
ª
Attaching the battery
Push the battery against the battery holder and
slide it until it clicks.
ª
Removing the battery
While sliding the [BATTERY] lever, slide the
battery to remove it.
≥Hold the battery with your hand so it does not
fall.
≥Before removing the battery, be sure to set the
[OFF/ON] switch to [OFF].
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
1
BATTERY
S5660.book 14 ページ 2006年10月30日 月曜日 午後6時56分