Filter
Top Products
1 A
Camera input (CAMERA IN)
Video output (VIDEO OUT)
When connected to a Panasonic Car Monitor etc., the image from the camera is automatically
displayed in the screen when the shift lever is moved to reverse (R).
O
For some combinations of vehicle type and device, additional cords (option) may be
required, or connection may not be possible.
Consult your dealer or service center.
O
For connection with products from other companies, consult the manufacturer of each
device.
Note:
O
Insert connectors securely. Also, take care to avoid pulling on the cords.
O
Do not extend the RCA cord or rear view camera cord, as video noise and breakdowns could
result.
O
Only use clip connectors in the specifi ed places.
Always wear gloves for safety during
wiring and mounting operations.
Q Installation procedure
Disconnect the battery
terminal.
Make wiring connections.
O
To avoid short circuit accidents, do not
connect the power cord connectors until all
wiring is complete.
Mount the components.
Reconnect the battery
terminal.
Make connections and set and operate acc
o
Rear view camera
control unit
Power cord
(5 m)
RCA cord
(6 m)
Rear view camera
(4 m)
Ground lead
(Black)
Fuse 1 A
Reverse lead
(Violet/white stripe)
(Yellow)
To camera image input terminal or video
input terminal
To a metal part of the vehicle body
To the
wire of the reverse lamp
(Yellow)
Connect to an area of exposed metal, not
covered with paint etc.
Do not connect to a point that has a
constant power supply.
Power connector (POWER)
NTSC Only
Wiring procedure