Filter
Top Products
-40-
Notes:
• When the “I” cursor reaches the “+” end, it
jumps back to “–”. At the same time, COARSE is
incremented by one step to enable a continu-
ous adjustment. The reverse takes place when
the “I” cursor reaches the “–” end.
• When
L or M is kept pressed for a second
or more, the “I” cursor moves faster.
• To reset COARSE and FINE to the values pre-
set at the factory, press
L and M simultane-
ously. COARSE and FINE adjustments are pre-
set at the factory to zero-crossing of the AC line
phase.
• If the AC line contains noise (spike noise, etc.),
the stability of the vertical phase of the camera
video output signal may be disturbed.
7. White Balance Setting (WHITE BAL)
7-1. Auto-Tracing White Balance Mode (ATW)
You can select one of four modes for white balance
adjustment as follows:
•ATW1 (Auto Tracing White Balance 1)
In this mode, the colour temperature is monitored
continuously and thereby white balance is set auto-
matically. The colour temperature range for the
proper white balance is approximately 2 600 -
6 000K. Proper white balance may not be obtained
under the following conditions:
1. The colour temperature is out of the 2 600 -
6 000K range.
2. When the scene contains mostly high colour
temperature objects, such as a blue sky or sun-
set.
3. When the scene is dim.
In these cases, select the AWC mode.
Move the cursor to WHITE BAL and select ATW1.
The white balance of the camera is automatically
set.
•ATW2 (Auto Tracing White Balance 2)
Auto-tracing white balance of the sodium light
mode (ATW2)
In case that you select ATW2 for sodium light, white
balance is set automatically (Operation is not need-
ed).
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON(DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
RET
↵↵
↵
↵