Filter
Top Products
5. Attach the safety wire for securing the camera to
the mounting base.
Pull on the safety wire to make sure its ring is
securely connected to the mounting base hook.
If the dust protection sheet that comes with the
camera is affixed to the mounting base, remove it
before performing the above step.
Note: The safety wire is designed to allow the
camera to hang from it. Do not apply force greater
than the weight of the camera to the wire.
6. Install the camera onto the mounting base.
Aligning with the mounting base, press down on the
camera as far as it will go and rotate in the direction
indicated by the arrow.
7. Use the fixing screw you removed in step 1 to
secure the camera to the mounting base.
8. Check the installation.
• Is the camera is level and installed securely?
• Is the camera free of looseness?
• Does the fixed part of the camera remain in place
when you try to rotate it?
9. Separate the two parts of the decorative cover
(comes with camera).
Press upwards on the decorative cover at the
points marked (indicated by the arrows, in the
illustration below) to unhook the two parts from
each other.
* When removing the decorative cover, the direction
to press ( ) is shown on the side of the decorative
cover.
Caution: Pressing up on the wrong side of the
decorative cover can damage it.
10.Put the two pieces of the decorative cover on the
left and right side of the camera, and hook them
together.
Align the hooks and press the piece indicated by
the arrow in the illustration below into the other
piece.
11.Slide the decorative cover up to the ceiling.
• In the case of a top cable exit configuration, slide
the decorative cover straight up and press it firmly
against the ceiling.
• In the case of a side cable exit configuration, align
the cutout in the decorative cover with the cables
as you slide it up, and press it firmly against the
ceiling.
➡
-16-
Safety
wire ring
Camera
Camera
Mounting
Base
Rotate
15°
Unhook
Back
Fix securely
Press
Fix securely
Press
Press
Hold
securely
Back
Hold
securely
Align
hook
Press
Top Cable Exit
Configuration
Side Cable Exit
Configuration
Align with
cutout