Filter
Top Products
[Alarm image attachment]
Select “On” or “Off” to determine whether or not to attach an image to the E-mail to be sent when an alarm is
detected.
• Default: Off
Note
• The settings for “Image capture size” of the “Alarm image” section on the [Alarm] tab (®page 115) will
be applied to the size of the image to be attached.
• When “3 mega pixel [4:3]” is selected for “Image capture mode”, images cannot be attached.
Destination of notification
[Address 1] - [Address 4]
Enter the destination E-mail address. Up to 4 destination E-mail addresses can be registered.
• [Alarm] checkbox: When the checkbox is selected, the E-mail notification will be performed upon an alarm
occurrence.
• [Diag.] checkbox: When the checkbox is selected, the E-mail notification will be provided in the following
cases.
– When notification of the remaining capacity of the SD memory card has been provided
– When the SD memory card has become full
– When the SD memory card cannot be recognized
• [Destination E-mail address]: Enter the destination E-mail address.
– Available number of characters: 3 - 128 characters
– Available characters: Alphanumeric characters, the at sign (@), the period (.), the underscore (_),
and the hyphen (-).
To delete the registered address, click the [Delete] button respective to the desired address.
[E-mail subject]
Enter the E-mail subject.
• Available number of characters: 0 - 50 characters
[E-mail body]
Enter the E-mail body.
• Available number of characters: 0 - 200 characters
Note
• Notification E-mail will be sent with the message “The capacity of the SD memory card is full.” when
the SD memory card has become full, or “The SD memory card cannot be detected.” when mounting
of the SD memory card failed.
13.8 Configure the settings relating to Panasonic
alarm protocol [Notification]
Click the [Notification] tab on the “Alarm” page. (®page 46, page 48)
Operating Instructions 125
13 Configure the alarm settings [Alarm]