Filter
Top Products
4
Model 3088 Quick Start Guide
Figure 2.
Model 3088/CA front panel
2.3 Power up indication
Verify that the
Power
LED (see
figure 2
) illuminates and remains lit.
3.0 Connect the G.SHDSL port
1.
Obtain single-twisted-pair cable with an RJ-45 plug connector at each end.
2.
Plug one end of the cable into the RJ-45 socket (labelled
DSL)
on the RocketLink-G NTU.
—
If you are connecting to a DSL service
, plug the other end of the cable into the RJ-45 wall
socket that provides your G.SHDSL service.
—
If connecting to another RocketLink-G,
verify the other end of the cable is connected to the
DSL port on other RocketLink-G and the DSL port is correctly configured.
3.
When a DSL link is established, the front-panel
DSL
LED will turn on.
4.0 Connect the serial port
Your RocketLink-G comes with one of the following serial WAN ports for connection to an NTU:
•
V.35 (DB-25F)—Model 3088/CA
•
X.21 (DB-15)—Model 3088/D
•
T1/E1 (120-Ohm RJ-48C and dual 75-Ohm BNC connectors)—Model 3088/K
•
T1/E1 (RJ-48C)—Model 3088/T
DSL
Terminal
Console
TM / ERR
Power