Filter
Top Products
4 Pelco Manual C1969M-A (1/02)
INSTALLING THE CAMERA
1. Assemble and mount the camera and bracket.
NOTE:
The screws provided are intended for wood. If it is necessary to substitute
screws for masonry or hollow wall mounting, be sure to use #6 or 4 mm hardware.
2. Run cables. Refer to
Installation Tips
.
Figure 1. Connections at the Back of the Monitor
BALL JOINT
THUMB NUT
SET SCREW
BRACKET
BRACKET BASE
CAMERA
THUMB NUT
SET SCREW
20103
MAIN
A/C INLET
CH 1
IN
IN/OUT
CH 3 CH 4CH 2
REMOTE
*
CH 1 CH 2 CH 3 CH 4 TRIG
OUT
IN
OUT
MONITOR
OUT
VIDEO AUDIO
75 Hi 75 Hi 75 Hi 75 Hi 75 Hi
SCREEN
FOCUS
TO AC
OUTLET
TO VCR (OPTIONAL)
IF AUDIO IS USED
TO VCR
TRIGGER
ALTERNATE ALARM CONTACT
(WHEN CONTACTS ON THE
CAMERA ARE NOT USED)
CAMERA 1 CAMERA 2 CAMERA 3 CAMERA 4
*NOT USED IN STANDARD INSTALLATION. CONTACT
PELCO IF REMOTE CONTROL IS REQUIRED.
TO VCR (WHEN AUDIO
IS NOT USED)
MIC
MONITOR
ALARM
IN GND
20105
MIC
MONITOR
ALARM
IN GND
MICROPHONE
20106
MIC
MONITOR
ALARM
IN GND
N.C. OR N.O. CONTACT
20107
3. Connect cable to camera. Insert plug with the arrow facing up.
4. Connect alarm contacts, if used.
5. Connect cable to one of the CH IN jacks on the back of the monitor
(refer to Figure 1).
6. Set impedance switch to the 75-ohm position,unless another video
device is connected to the IN/OUT jacks (refer to Figure 1).
7. Connect AC power to monitor (refer to Figure 1).
8. Turn on MAIN switch on the back of the monitor (refer to Figure 1). Then press the POWER button on the front of the monitor.
9. Test according to the checkout procedure in Table A.