Filter
Top Products
Pelco Manual C2408M-F (4/03) [ 3 ]
IMPORTANT SAFEGUARDS AND WARNINGS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
6. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
7. Only use attachments/accessories specified by the manufacturer.
8. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
9. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
10. To reduce the risk of shock do not perform any servicing other that that contained on the operating
instructions unless you are qualified to do so.
11. Installation should be done only by qualified personnel and conform to all local codes.
12. Unless the unit meets NEMA Type 3, 3R, 3S, 4, 4X, 6 or 6P standards, it is designed for indoor use
only and must not be installed where exposed to rain and moisture.
13. Use only installation methods and materials capable of supporting four times the maximum specified
load.
14. Use stainless steel hardware to fasten the enclosure to outdoor surfaces.
15. To prevent water leakage when installing an enclosure outdoors, apply sealant around the bolt holes
between the enclosure and mounting surface and to the notch in the base of the enclosure.
DESCRIPTION
The 300 Series Camclosure
®
integrated camera system is a track-light design that mounts to a wall or
ceiling. The system incorporates a camera and lens package into a small, unobstructive, medium-security
enclosure designed for areas subject to vandalism. The system is quick and easy to install in a variety of
indoor or outdoor applications. It is ideal for residential, office, mall, hospital, school, parking garage,
correction and detention, and other medium-security installations subject to vandalism.
INSTALLATION
The following parts are supplied:
1 Camclosure integrated camera system
2 9-pin electrical connectors (12 VDC and 24 VAC)
1 Hollow screwdriver bit (1/8-inch)