Filter
Top Products
IMPORTANT SAFEGUARDS AND WARNINGS
Prior to installation and use of this product, the following WARNINGS should be observed.
1. Installation and servicing should only be done by qualified service personnel and conform
to all local codes.
2. Unless the unit is specifically marked as a NEMA Type 3, 3R, 3S, 4, 4X ,6 or 6P enclo-
sure, it is designed for indoor use only and it must not be installed where exposed to rain
and moisture.
3. Only use replacement parts recommended by Pelco.
The product and/or manual may bear the following marks:
Please thoroughly familiarize yourself with the information in this manual prior to installation
and operation.
DESCRIPTION
The EH1000 low-profile ceiling enclosure for 2/3-inch format cameras is designed to be mounted
in fixed or dropped ceilings. The upper section mounted above the ceiling is constructed of alu-
minum to meet most fire code requirements for installation in open plenum ceilings.
The EH1000 is engineered for ease of installation and service. The lower section is hinged to
provide convenient access for adjusting camera and lens. The upper section has generous
interior dimensions which allow additional camera angle adjustments to be made.
The EH1000 is equipped with a tamper-resistant lock for security protection. Cable entry is
through conduit knockouts.
INSTALLATION
To mount the EH1000 directly into a fixed or dropped ceiling, perform the following steps:
1. Determine the location and direction of the enclosure to be mounted. Ideally, the enclo-
sure cutout should be parallel and adjacent, or perpendicular, to any ceiling structure.
Avoid cutting into any ceiling structural members.
2. Open the cover of the enclosure to expose the mounting holes in the flange.
3. Remove any appropriate knockouts.
4. Insert the enclosure into the opening and secure with the appropriate fasteners.
5. Mount the camera and lens onto the adjustable mounting bracket. Adjust the position of
the camera and lens to clear the enclosure cover when closed. Tighten the mounting
bracket fasteners.
6. Route the appropriate cables into the enclosure. Make all necessary electrical connec-
tions.
7. Close and lock the cover.
C401M-C (12/99)
EH1000
Ceiling Enclosure
®
This symbol indicates that danger-
ous voltage constituting a risk of
electric shock is present within
this unit.
This symbol indicates that there
are important operating and main-
tenance instructions in the litera-
ture accompanying this unit.
CAUTION:
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
3500 Pelco Way,
Clovis, CA 93612-5699
USA
In North America & Canada:
Tel (800) 289-9100
FAX (800) 289-9150
International Customers:
Tel +1 (559) 292-1981
FAX +1 (559) 348-1120
www.pelco.com
NOTE:
The camera mounting
bracket is reversible, to accom-
modate various camera and lens
combinations.