Filter
Top Products
Pelco Manual C458M-B (1/98) 11
3.3 CAMERA/LENS INSTALLATION
Install the camera/lens you have selected for use with the IDS14 series dome as
follows:
1. Loosen the 1/4-20 lens support fastener (item 1 in Figure 3) and slide lens
support down.
2. Attach camera/lens to the tilt table with the 1/4-20 x 3/4" bolt, flat washer, and
lock washer (items 2 in Figure 3) that are provided.
If the camera/lens can be balanced on the tilt table, the life of the dome drive
will be extended.
3. Now slide the lens support up to the lens and, if applicable, fasten with
the 1/4-20 x 1/2" bolt, flat washer, and lock washer (items 3 in Figure 3) that
are provided.
4. Connect camera power spade lugs, coax video cable and lens connector, paying
special attention to the routing of your cabling so as not to interfere with the
camera/lens swing.
Proceed to Section 3.4, ADJUSTMENTS.
3.4 ADJUSTMENTS
1. Turn on the power. If, the unit has an integral receiver/driver, it will begin to
move in about 15 seconds and go through its start-up routine.
2. Refer to the manual for the camera/lens to set the switches on the camera as
required for your application.
Figure 3. Attaching Camera/Lens to Tilt Table
(3)
(2)
(1)