Filter
Top Products
2 Pelco Manual C720M (1/96)
4.0 INSTALLATION
CAUTION: Make certain not to drop or jar
the camera and lens combination or damage will
result to the unit.
To install the camera and lens package in your dome,
please follow the steps outlined below. Refer to Figure
2, if necessary.
1. Disconnect main power to back box.
2. Remove dome drive from back box.
3. Insert the two (2) 1/4-20 studs on the IOP package
through the slots in tilt table with the IOP facing
the front of the tilt table. From the bottom place a
split lock washer and a 1/4-20 nut on each stud.
Tighten down nuts just snug.
4. Make all electrical wiring and other connections
as shown in Figure 3.
5. Insert the dome drive into the back box. Adjust the
IOP package on the tilt table so that it is as close to
the dome as possible (without hitting when tilted
up or down). Then securely tighten nuts on IOP
package.
Figure 2. IOP Package Installation