Filter
Top Products
Pelco Manual C1498M-B (7/99) 11
Software controls scan limit stops. When the dome reaches one, it immediately reverses
direction. Refer to the
Limit Stops
section to program the scan limit stops. Program preset
96 (29) to stop a scan. Any pan and tilt or lens command also stops a scan.
PARK
If the dome does not receive any commands for a specified period, it goes to preset 1 and
parks. The dome will not park if the time specified is zero or preset 1 has not been
programmed. The default is zero minutes.
PROGRAMMING THE SPECTRA
LITE™
The dome can be programmed for the following functions:
AGC (automatic gain control) Camera reset Scan speed
Auto flip disable Gain Sharpness
Auto focus Limit stops Shutter speed
Auto park time Power line synchronization White balance
Backlight compensation Power-up mode
The main menu contains four secondary menus: Camera, Line Sync, Power Up, and Other.
Each secondary menu has submenus, which are structured as follows:
1. Camera
First Camera Submenu Second Camera Submenu
Backlight comp Shutter speed
Reset camera Auto focus mode
Gain/AGC Sharpness
AGC mode Sharpness
Gain White balance
Auto-iris Auto white bal
Auto-iris mode White bal hue
Auto-iris level Prev (to first camera submenu)
Next (to second camera submenu)
2. Line Sync 3. Power Up 4. Other
Line sync Power up Auto flip
Line sync phase Limit stops
Park time minutes
Scan speed deg/s
The following sections explain how to program the Spectra
Lite™ dome using the menu choices.
MAIN MENU ACCESS
You can call up the main menu on your monitor by programming (setting or creating) preset
95 (28). Programming preset 95 for Pelco’s controllers varies according to the type of
controller you are using. Below are instructions for programming preset 95 for various Pelco
controllers.
CM6700
1. Enter the number of the Spectra
Lite™ camera and press the CAM key.
2. Enter 95 and hold the PRESET key for two seconds.
3. In the Edit Preset menu, arrow to SET and press the ACK key. The main menu appears.
CM8500
1. Enter the number of the Spectra
Lite™ camera and press the CAM key.
2. Highlight PRESET in the Camera menu and hold down the joystick button until the Set
Presets prompt appears.
3. Enter 95 and press the PRESET key. The main menu appears.
CM9500
1. Enter the number of the Spectra
Lite™ camera and press the CAM key.
2. Press the SELECT key twice.
3. Highlight CAM in the Setup menu and press the SELECT key.
4. Highlight PRESET in the Camera menu and press the SELECT key.
5. Enter 95 and press the F1 key. The main menu appears.