Filter
Top Products
Pelco Manual C1498M-B (7/99) 15
To change the mode:
1. On the main menu, move the joystick up or down to position the cursor (>) beside Camera.
2. Press the Iris Open button to enter the Camera submenu.
3. Move the joystick up or down to position the cursor beside Next.
4. Press the Iris Open button to go to the next camera submenu.
5. Move the joystick up or down to position the cursor beside Auto-Focus Mode.
6. Press the Iris Open button. The cursor moves to the right beside the word Auto or Off.
7. Move the joystick up or down to toggle between Auto and Off.
8. SELECT – Press the Iris Open button to select your choice.
CANCEL – Press the Iris Close button if you do not want to change the setting.
SHARPNESS
To manually adjust the picture sharpness:
1. On the main menu, move the joystick up or down to position the cursor (>) beside Camera.
2. Press the Iris Open button to enter the Camera submenu.
3. Move the joystick up or down to position the cursor beside Next.
4. Press the Iris Open button to go to the next camera submenu.
5. Move the joystick up or down to position the cursor beside Sharpness.
6. Press the Iris Open button to move the cursor to the right beside the value.
7. Move the joystick up or down to a value. As you change the value, you can see the
sharpness change. Press the Iris Open button to select the value, or press the Iris
Close button if you do not want to change the setting.
WHITE BALANCE
The two white balance settings are auto and white balance hue. To change the white
balance setting:
1. On the main menu, move the joystick up or down to position the cursor (>) beside Camera.
2. Press the Iris Open button to enter the Camera submenu.
3. Move the joystick up or down to position the cursor beside Next.
4. Press the Iris Open button to go to the next camera submenu.
5. Move the joystick up or down to position the cursor beside White Balance.
6. Press the Iris Open button. Another menu appears with the auto and white balance
hue selections.
7. Move the joystick up or down to position the cursor beside one of the choices. Press
the Iris Open button.
AUTO WHITE BALANCE – Move the joystick up or down to toggle between the Auto
and Off choices. Press the Iris Open button to select one, or press the Iris Close button if
you do not want to change the setting.
WHITE BALANCE HUE – Adjust the color by moving the joystick up or down to a value
between 1 (blue end of the spectrum) and 99 (red end). Hold the joystick up or down to fast
forward or fast reverse through the values. As you change the value you can see the color
change on your monitor. Press the Iris Open button to select the value, or press the Iris
Close button if you do not want to change the setting. If Auto White Balance is on, it
changes to off when you select a new value.
LINE SYNCHRONIZATION
You can turn line synchronization on or off.
• If it is on, you can adjust the synchronization of the power line voltage so it is in phase
with other cameras. If cameras are out of phase with each other, they may produce
what appears to be vertical roll when switching between cameras.
• If it is off, the dome synchronizes to an internal clock.