Filter
Top Products
C1671M (5/05) 7
16. In the CMOS Setup Utility, select Advanced BIOS Features. Press the Enter key.
17. In the First Boot Device dialog box, scroll to HDD-0 and then press the Enter key to make the hard drive the first boot device.
18. Press the F10 key to save the change.
19. A message appears in the center the screen asking if you want to “SAVE to CMOS and EXIT (Y/N)?” Type
Y
and then press the Enter key.
The DX7100 reboots.
20. The DX7100 recovery procedure is complete, and your recorder should be ready to use again. Remove the DX7100 Recovery CD from the
CD-ROM drive.
REVISION HISTORY
Manual # Date Comments
C1671M 5/05 Original version.
Pelco and the Pelco logo are registered trademarks of Pelco. ©Copyright 2005, Pelco. All rights reserved.