Pelco IV SE Security Camera User Manual


 
14 C3418M-B (11/06)
Weight (approximate)
Back Box
Standard Pendant 2.4 lb (1.09 kg)
Environmental Pendant 3.5 lb (1.59 kg)
Dome Drive 3.3 lb (1.48 kg)
Lower Dome 0.2 lb (0.09 kg)
ELECTRICAL (Dome Drive Only)
Input Voltage 18-32 VAC; 24 VAC nominal
22-27 VDC; 24 VDC nominal
Input Power
24 VAC 23 VA nominal (indoor, without heater)
73 VA nominal (outdoor, with heater)
24 VDC 0.7 A nominal (indoor, without heater)
3 A nominal (outdoor, with heater)
Fuse 1.25 A
Auxiliary Outputs 2 (Spectra IV SE only)
Alarm Inputs 7 (Spectra IV SE only)
Relay Contacts AUX 1
AUX 2 Output
Type Form C Open collector
transistor output
Voltage Low voltage (<40 V) 32 VDC maximum
Current 2 A maximum 150 mA maximum
Specifications
5.9 (15.0)
10.6
(26.9)
8.6 (21.8)
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS;
ALL OTHERS ARE INCHES.
GENERAL
Construction
Back Box Aluminum
Dome Drive Aluminum, thermoplastic
Lower Dome Acrylic
Cable Entry (Back Box) Through 1.5-inch NPT pendant
mount
Pan Movement 360° continuous pan rotation
Vertical Tilt Unobstructed +2° to -92°
Manual Pan/Tilt Speeds*
Pan 0.1°- 80°/sec manual operation,
150°/sec turbo
Tilt 0.1°- 40°/sec manual operation
Preset Speeds
Pan 400°/sec
Tilt 200°/sec
Environment Indoor/outdoor
Operating Temperature
Standard Pendant (Assumes no wind chill factor)
Maximum 140°F (60°C) absolute maximum
in shade; 122°F (50°C) sustained
maximum in shade; 113°F (45°C)
absolute maximum in direct sun-
light; 95°F (35°C) sustained maxi-
mum in direct sunlight
Minimum 25°F (-4°C) sustained minimum
Environmental Pendant (Assumes no wind chill factor)
Maximum 140°F (60°C) absolute maximum ;
122°F (50°C) sustained maximum
Minimum -60°F (-51.1°C) absolute mini-
mum; prevents icing at sustained
minimum of -50°F (-45°C);
de-ices 0.1 inch (2.5 mm) within 3
hours after power-up
*For variable-speed operation an appropriate controller is
required. With fixed-speed controllers, pan/tilt speed is 20°/
sec. The CM6700/CM6800 controller with the KBD200A
keyboard has programmable fixed speeds.
The materials used in the manufacture of this document and its components are compliant to the requirements of Directive 2002/95/EC.
This equipment contains electrical or electronic components that must be recycled properly to comply with Directive 2002/96/EC of the
European Union regarding the disposal of waste electrical and electronic equipment (WEEE). Contact your local dealer for procedures
for recycling this equipment.