Filter
Top Products
Pelco Manual C2423M (5/00) 13
AUTO IRIS
The following are the settings for auto iris:
Mode
Level
To change the settings for auto iris:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Camera.
3. Press the Iris Open button to enter the Camera menu.
4. Position the cursor (>) beside Auto-Iris.
5. Press the Iris Open button. The Auto Iris menu appears.
6. Position the cursor (>) and select one of the following settings:
MODE - The cursor moves to one of two choices:
Auto - The iris is automatically adjusted to produce a constant video output as deter-
mined by the Level setting.
Off - Auto iris is disabled, and control is always manual.
Move the joystick up or down to toggle between Auto and Off. Press the Iris Open
button to select the choice, or press the Iris Close button if you do not want to change
the setting.
LEVEL - The cursor moves to a numeric value, which the dome uses to try to
maintain a certain light level. Changing the value of the Level setting will change the
video level to which the auto iris adjusts. This setting should be adjusted if the video
level in the auto iris mode is too bright or too dark. Move the joystick up or down to a
value. Press the Iris Open button to select the value, or press the Iris Close button if
you do not want to change the setting.
Main Menu
<Camera>
<Line Sync>
<Power Up>
<Aux>
<Alarms, Zone Blank>
<Other>
EXIT
Auto-Iris Menu
Auto-iris mode Auto
Auto-iris level 7
Exit
Camera Menu
Backlight comp Off
Zoom limit x72
Reset camera
<Gain/AGC>
<Auto-iris>
<Next>
Exit