Filter
Top Products
C2223M-A (2/06) 3
Installation
The following parts are supplied:
1 Adapter plate with locking screw
1 Wall mount
2 8-32 x 0.75-inch screws
To install the SWM4-W wall mount:
1. Run 24 VAC power, video (coax or UTP), and camera control wiring to the mounting location. If
you are using coax video, do not attach a BNC connector to the cable until step 5. Refer to Table
D, Table E, and Table F in the installation manual for the Spectra Mini dome for wiring
information.
2. Thread the 24 VAC power, video (coax or UTP), and control wiring through the large access hole
in the adapter plate. Then attach the adapter plate to the mounting surface using either the
top/bottom or left/right pair of mounting holes. (The top/bottom pair is shown in Figure 1.)
NOTE: If mounting to anything other than a junction box, select appropriate mounting hardware
for the mounting surface.
Figure 1. Mounting the Adapter Plate