Filter
Top Products
49
3
Basic Operations
The [Shake Reduction] menu appears when the camera is turned on with the
Shake Reduction switch on and a type of lens that does not support automatic
acquisition of lens information such as focal length (p.47) is mounted.
Use the [Shake Reduction] menu to set the [Focal Length].
1
Use the four-way controller
(op) to set [Focal Length].
Select from the following 34 focal length
values. (The default setting is 35.)
2
Press the 4 button.
The camera is ready to take a picture.
Setting the Shake Reduction Function
• [Focal Length] cannot be set manually on the [Shake Reduction] menu when
using a lens that supports automatic acquisition of lens information such as
focal length because [Focal Length] is set automatically.
• Set [FI with S lens used] on the [A Custom Setting] menu to [Available] to
enable the focus indicator when using a screw mount lens. If this is set to
[Unavailable], the camera assumes there is no lens attached, and the Shake
Reduction function cannot be used.
• When using a lens without the s position on the aperture or with the aperture
set to a position other than the s position, set [Using aperture ring] on the [A
Custom Setting] menu to [Permitted].
8 101215182024283035
40 43 50 55 65 70 77 85 100 120
135 150 180 200 250 300 350 400 450 500
550 600 700 800
• If the focal length for your lens is not listed above, select the value closest to
the actual focal length.
• When using a zoom lens, select the actual focal length at the zoom setting in
the same manner.
• Effect of Shake Reduction is influenced by the shooting distance as well as
focal length information. The Shake Reduction function may not perform as
expected when shooting at close ranges.
To change the [Focal Length] setting, use [Shake Reduction] on the [A Rec.
Mode] menu. (p.104)
Cancel
OK
OK
Shake Reduction
135
120
100
Focal Length